BISSELL ProHeat 2x

Bissell steam cleaners will keep carpet clean and give you a nice impression in front of your friends, visitors and family members. It is important to keep everything at home clean, especially curtain and carpet.

They are one of the best vacuums. It is able to clean dirt and debris on the floor and to get rid of stains without having to get down on your knees and scrub at it for hours. To help prevent future stains from coming back, the Bissell steam carpet cleaners will have applied a layer of scotch guard over them.

Bissell ProHeat 2X Select Upright Deep Carpet Cleaner, 9400

All of above are the reason that more people prefer to keep Bissell cleaners at home. Having dirty carpet with bad smell, it is not easy to select the proper carpet cleaner, since there are many different cleaners at the marketplace. Bissell are the name that you will hear.

Bissell units have a built-in-heater feature. To get your carpet cleaner, it will heat tap water up to 25 degrees holter. Mix with the amount of water you have put in and the right amount of cleaning solution, the system will automatically measure. Here are some simple explanations how to troubleshoot your unit.

  1. If the SmartTemp Ready Light doesn’t illuminate, turn On the SmartTemp switch, it may be in the off position. Both switches must be in the On position to activate the SmartTemp Ready Light. The machine’s power switch is turned out should be assured.
  2. If the spray is reduced or not coming out at all, refill the tank with hot water. If the SmartMix bottle is empty should be checked. If the filter is clogged, you may need to clean, since clogged give you a problem for you. The tanks are seated properly should be assured. Turn the power Off if these steps don’t work, then after a minute, turn it On again. Once you turn it back on again, the pump may have lost prime, depress the trigger.
  3. If you think the pump belt may be broken, turn the machine off and unplug it from the outlet. Release the lower snap; insert the blade of a flat head screwdriver into the lower slot of the belt access door to check if it is broken. The pump belt looped around the motor shaft should be able to see and tell if it is broken. To how to obtain a new one, you should consult the user’s manual.